Barix Exstreamer 500 Audio Over IP Encoder/Decoder w/Balanced Audio

MSRP: $730.00
$0.00
(You save $730.00 )
Write a Review
SKU:
BAR-EXSTREAMER500
Availability:
Normally ships from BGS, contact us for availability
Type:
Codec
Adding to cart… The item has been added

Overview

Professional Multiprotocol IP Audio de-/encoder with I/O, balanced audio. Support of Internet Radio and VoIP (SIP, RTP) codecs and protocols make the products the ideal choice for broadcast, professional and VoIP
applications.

  • MP3, G.711, G.722*, PCM Encoding
  • MP3, G.711, G.722*, PCM, AACplus*, Ogg Vorbis*Decoding
  • Shoutcast/Icecast Source capability
  • Audio Level Supervision with SNMP Trap generation
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Balanced Line Level Input (Stereo)
  • Balanced Line Level Output (Stereo)
  • Relay Output (4)
  • Contact Closure Input (4)
  • RS-232 / RS-485 Serial Port
  • USB Flash Memory Interface
  • Supply Voltage 24...48 VDC

 

Applications

  • Live IP Audio Encoder for Streaming Applications
  • Generic, bidirectional full-duplex VoIP module for Paging and Intercom Applications
  • Paging and Audio Distribution with external Amplifier control and monitoring
  • Shoutcast/Icecast Source Encoder
  • Confidence Monitoring and Vox Switch forBroadcast Applications
  • Commercial Audio Streaming Applications
  • Multiroom IP Audio System Receiver
  • Low latency IP Audio Encoder for multichannel applications
  • Background Music and Music-on-Hold encoder for VoIP Applications
  • Source Encoder for IP Audio Distribution Applica ions
  • Digital Annunciator, Message Player, Message Repeater
  • SIP and IP Paging Zone Device
  • Reflector based STL application

 

Specifications

Electrical

  • 24 to 48 VDC ± 20%
  • Power requirement: 8 Watt max.
  • 2 pin screw terminal connector

Ethernet

  • 10/100Mbps auto,
  • RJ-45 connetor with integrated Link & Activity LEDs
  • Protocols: TCP/IP, UDP, RTP, DHCP, Multicast capable

Analog Inputs & Outputs (stereo)

  • DB9 female socket
  • Optionale XLR Cable Set

 

Analog Inputs

  • Differential input, 18kOhm input impedance
  • Clipping level 15dBu, 12.3 Vpp
  • Frequency response (-3dB) 20..20'000 Hz**
  • Signal to Noise Ratio 87 dB, THD 0.01%
  • Stereo crosstalk -88 dB
  • Input level software controllable (-3.. +19.5dB)

Analog Outputs

  • Differential output, 40..60 Ohm output impedance
  • Output level software controllable
  • Full scale output voltage: 15dBu, 12.3 Vpp
  • Frequency response (-3dB) 20..20'000 Hz**
  • Signal to Noise Ratio 92dB, THD 0.03%
  • Stereo crosstalk -66 dB

RS-485

  • 4 pin screw terminal connector
  • 300..230'400 Baud asynchronous, 7/8 bit

RS-232 INTERFACE

  • Male 9-pin Sub-D connector
  • .230‘400 Baud asynchron., tunneling or local control
  • 12 VDC supply output for external device (100 mA max.)

Audio formats

  • Encoding and decoding MP3 in variable and constant bit rate
  • ( VBR/CBR*, 8kbps..320kbps) at 8..48kHz sample frequency
  • PCM (L16, uLaw, aLaw) at 8..48kHz sample frequency
  • Decoding AAC+* (AAC-LC, HE-AAC, HE-AAC v2)

Discrete I/O

  • Two 6 pin screw terminal connectors
  • 4 contact closure sensing inputs
  • 4 relay contacts, 24V 0.5A, normally open

Mechanical

  • Aluminum case, 620g, rack mountable using accessory bracket

Dimensions (W x H x D)

  • 216x38x125mm (8.5x1.5x4.92 inch)

 

MTBF According MIL217F at 25°C

  • Exstreamer 500 min. 410 000h

 

* Exstreamer 500 Hardware revision 2 only

** depends on used codec, best results @48kHz PCM

The warranty period for defects due to material flaws, design errors or demonstrably careless work within the framework of software development lasts for two years with regard to hardware and one year with regard to software. The warranty period begins when the delivery is dispatched by Barix (for hardware or standard software) or upon acceptance of the software by the contractual partner (for individually developed software). If the contractual partner has purchased the product for the purpose of resale, carefully stored it and not used it, the warranty period is extended by the amount of time during which the product is stored at the contractual partner's site, but by no longer than one year. The contractual partner undertakes to notify Barix in writing (along with a detailed description) immediately, and no later than within 20 days, of any hidden defects identified during the warranty period. The warranty is excluded in the case of defects which would have been identifiable during a proper inspection of the products, as specified in point 7 of these General Terms. The warranty is also excluded for defects which Barix is not responsible for, e.g. natural wear and tear, force majeure, treatment and usage by the contractual partner or third parties which is inappropriate and contrary to regulations and purpose, interventions by the contractual partner or third parties, excessive loads, unsuitable equipment, faulty maintenance or extreme environmental influences, as well as in the case of modifications made by the contractual partner to the products before reselling them to third parties. Barix does not guarantee that the products which it delivers, processes or develops can be used uninterruptedly and absolutely flawlessly. Barix undertakes to repair or replace, at its own discretion and as quickly as possible, products which are demonstrably defective during the warranty period due to the use of bad-quality materials, faulty design or poor workmanship, or which do not have the contractually guaranteed features or functions. The contractual partner must provide Barix with all the relevant information for this. Replaced parts are the property of Barix. If it transpires that Barix is not responsible for a particular defect, the product will be repaired by Barix against payment. In the event of demonstrably defective performance on the part of Barix within the framework of an individual software development, the right of rectification is explicitly reserved. In each case, Barix is liable only for direct or indirect damage which has occurred at the contractual partner's site. Liability for indirect or consequential damage, such as lost profits, third-party claims or damage caused by the contractual partner's failure to comply with contractual obligations is thus explicitly excluded. The contractual partner does not have any further rights arising out of product defects other than those explicitly mentioned above.