Overview
The Annuncicom 1000 is a professional Audio over IP device. With balanced audio and supervised I/O, it is ideal to serve as a gateway between IP Paging, VoIP and Intercom systems.
Supporting both high quality music (MP3) as well as voice codecs (G.711 and G.722*) and a large number of protocols (including Shoutcast/Icecast, RTP, SIP etc), the device can be used for both surveillance as well as VoIP applications.
Applications
• VHF Radio Controller and interface to IP
• Microphone Encoder for IP Audio Surveillance
• Automatic Announcement Systems
• Voice Evacuation Systems
• Paging and Audio Distribution with Amplifier control and monitoring
• Live IP Audio Encoder for Streaming Application
• Generic, bidirectional full-duplex VoIP module for Paging and Intercom applications
Features
- MP3, G.711, G.722*, PCM Encoding
- MP3, G.711, G.722*, PCM Decoding
- Audio Level Supervision with SNMP Trap generation
- IP Streaming via TCP, UDP, RTP, Multicast
- Microphone Input
- Balanced Line Level Input (2)
- Balanced Line Level Output (2)
- Relay Output (8+1)
- Supervised Contact Closure Input (8)
- RS-232 Serial Port (1)
- RS-485 Serial Port (1)
- Supply Voltage (24-48VDC)
- Battery Backup Supply Input
Specifications
Audio Formats
- MP3 encoding up to 192 kBit VBR, CBR*, decoding up to
- 320 kBit (Stereo), G.711 (uLaw/aLaw @ 8 or 24 kHz), G.722* and PCM (16 bit @ 8 or 24 kHz)
Discrete Interfaces
- 8 supervised Inputs, 8 Relays (dry contacts)
- 1 Fault Relay output
Audio Interfaces
- Mic In (Balanced, Phantom power) or Balanced
- Balanced Stereo Line In, 18 kOhm impedance
- Input level software controllable
- Clippinglevel 3.5 dBu, 3.28 Vpp
- Frequency response (-3 dBFS) 20 .. 17000 Hz **
- Signal to Noise Ratio 88 dB, THD (-3 dBFS) < 0.1 %
- Stereo crosstalk -87 dB
- Balanced Stereo Line Out, 40 .. 60 Ohm impedance
- Output level software controllable
- Full scale output voltage 5.9 dBu, 4.33 Vpp
- Frequency response (-3 dBFS) 15 .. 21000 Hz **
- Signal to Noise Ratio 92 dB, THD (-3 dBFS) < 0.1 %
- Stereo crosstalk -66 dB
Serial Interfaces
- RS-232 DSub 9 pin male, 300..115200 Baud
- RS-485 screw terminal block, 300..115200 Baud
Control Interfaces
- web server for control and configuration
Network Interface
- RJ45 10/100 Mbit Ethernet (Auto), TCP/IP, UDP, RTP, SIP, DHCP, SNMP, AutoIP, SonicIP, IPzator
Misc
- Ten status LEDs, reset/factory default button
- Internal temperature sensor
Power inputs
- Two independent, level supervised inputs
- 24 to 48 VDC ±20% (pos. or neg.), 8 Watt max.
Case
- Aluminum, 745 g, 8.5" x 1.5" x 4.92" 216 mm x 38 mm x 125 mm
MTBF Min. 300 000h acc. to MIL217F at 25°C ambient temperature
The warranty period for defects due to material flaws, design errors or demonstrably careless work within the framework of software development lasts for two years with regard to hardware and one year with regard to software. The warranty period begins when the delivery is dispatched by Barix (for hardware or standard software) or upon acceptance of the software by the contractual partner (for individually developed software).
If the contractual partner has purchased the product for the purpose of resale, carefully stored it and not used it, the warranty period is extended by the amount of time during which the product is stored at the contractual partner's site, but by no longer than one year. The contractual partner undertakes to notify Barix in writing (along with a detailed description) immediately, and no later than within 20 days, of any hidden defects identified during the warranty period. The warranty is excluded in the case of defects which would have been identifiable during a proper inspection of the products, as specified in point 7 of these General Terms.
The warranty is also excluded for defects which Barix is not responsible for, e.g. natural wear and tear, force majeure, treatment and usage by the contractual partner or third parties which is inappropriate and contrary to regulations and purpose, interventions by the contractual partner or third parties, excessive loads, unsuitable equipment, faulty maintenance or extreme environmental influences, as well as in the case of modifications made by the contractual partner to the products before reselling them to third parties.
Barix does not guarantee that the products which it delivers, processes or develops can be used uninterruptedly and absolutely flawlessly.
Barix undertakes to repair or replace, at its own discretion and as quickly as possible, products which are demonstrably defective during the warranty period due to the use of bad-quality materials, faulty design or poor workmanship, or which do not have the contractually guaranteed features or functions. The contractual partner must provide Barix with all the relevant information for this. Replaced parts are the property of Barix. If it transpires that Barix is not responsible for a particular defect, the product will be repaired by Barix against payment.
In the event of demonstrably defective performance on the part of Barix within the framework of an individual software development, the right of rectification is explicitly reserved.
In each case, Barix is liable only for direct or indirect damage which has occurred at the contractual partner's site. Liability for indirect or consequential damage, such as lost profits, third-party claims or damage caused by the contractual partner's failure to comply with contractual obligations is thus explicitly excluded.
The contractual partner does not have any further rights arising out of product defects other than those explicitly mentioned above.
