Overview
ESE ES-410 GPS Based Frequency Generator
The ES-410 generates a stable source of 10 MHz and 1 PPS using GPS (Global Positioning System) satellites as a reference. The unit provides 10 MHz in both Sine Wave and Square Wave (5 volt logic) form. Four Sine Wave and four Square Wave outputs are provided. The 1 PPS output is a 50% duty, 5 volt logic signal, positive-edge coinciding with the UTC seconds change. An ESE TC90™ Time Code output is also provided for driving remote time displays. A USB interface allows configuration of the Time Zone and other parameters, and outputs the time. If frequency distribution is needed, we offer the ES-210, a Quad 1x6 1/5/10 MHz Distribution Amplifier. The ES-210 provides four independent 1x6 Frequency DAs in a single rack-mount enclosure.
- Disciplined Temperature-Compensated Crystal Oscillator
- GPS Timing Reference With 1 x 10-8 Accuracy
- Eight 10 MHz Outputs (4 Sine Wave & 4 Square Wave)
- Phase Coherent 1 PPS Output
- ESE Time Code Output
- Indoor/Outdoor Antenna with 16' Cable
- Ruggedized Desk-Top Enclosure
- USB interface
Specifications / Documents
- Outputs
- 10 MHz Sine Wave, BNC, 4 VPP into 50 ohms
- 10 MHz Square Wave, 5 VPP CMOS/TTL, BNC
- 1 PPS, 50% Duty, 5 VPP CMOS/TTL, BNC
ESE Time CodeTM (TC90) ,Drives 100 Slaves @ 4000’, BNC
- Accuracy: 1 x 10-8
- GPS Receiver: Internal 12-Channel
- Antenna: Indoor/Outdoor with 16’ Cable
- Antenna Input: L1, 1.57542 GHz, TNC
- Enclosure: Desk-Top, Black Anodized Aluminum
- Dimensions: 1.6” H x 10” W x 4.8” D
- Electrical: 117 VAC, 50/60 Hz
- Power: 5W maximum
Options
- Ant GPS Antenna: High Performance GPS Antenna for harsh RF Environments.
- BBU Battery Back-Up: An internal Gel-Cell battery is provided capable of maintaining the unit's microprocessor for up to a 4-hour power outage.
- DC DC Operation: Requires the unit to be powered from a DC source exclusively, typically +12 to +35 VDC.
- J 220 VAC/50 Hz Operation: The unit is configured to operate from 220 VAC line voltage. 117 VAC 50/60 Hz is standard.
- P 19" Front Panel (Rack Mount): Designed for mounting into a standard equipment rack. Panel is 1/8" black anodized Aluminum and chassis is 5" - 10" deep.
- UL "UL" Approved Power Supply: The unit is supplied with a UL/CSA approved wall mount power supply.
