Overview
Lectrosonics M2T Wireless IEM and IFB Transmitter with Dante - 470-607 MHz
The M2T Digital Half-Rack Transmitter with analog and digital Dante™ network audio inputs presents an excellent sounding IEM platform with a unique level of performance in a wireless in-ear monitor system. With ultra-low latency, digital RF modulation and two stereo digital channels, the M2T provides a truly unique IEM product for demanding, professional applications. The M2T includes a front-panel USB port for firmware updates and an IR port for fast setup. A large, high resolution, backlit LCD and large membrane switches provide an intuitive interface that is highly visible in daylight or dimly lit conditions.
The half-rack transmitter provides four audio inputs which can be individually configured to be analog or Dante compatible. The analog input connectors are full size XLR/TRS combo types for balanced line level signals. Input preamp circuits use a special balanced amplifier with very high common mode rejection to minimize hum and noise. Analog signals are converted to an internal digital format which is then encoded, organized into packets, and passed to an RF modulator. The modulated RF signal is filtered before and after amplification to suppress out-of-band noise and spurious signals.
Features
- IEM (Wireless Monitor) with digital RF transmission
- 2 independent stereo audio transmissions per 1/2 RU enclosure
- USB port for firmware updates
- Dante™ compatible
- AES 256 bit encryption with DCHX mode
- Up to 50 mW per RF carrier
- All-aluminum housing
- Compatible with Wireless Designer™ Software
Specifications / Documents
- RF Power Output: 25mW, 50mW; adjustable
- Antenna Output: 2 x BNC sockets
- Operating Frequencies: 470.1 – 607.975MHz
- Frequency Selection Steps: 25kHz
- Frequency Stability: ± 0.002%
- Modulation: 8 PSK
- Emission Designator: 200KG7E
- Equivalent input Noise: –128dBV
- Audio Frequency Response: 20HZ - 15KHZ, -3dB
- Audio Input: -10dBv or +4dBu settings with ±5dB trim
- Audio Input Jack: 4 x combo locking XLR / TRS connectors
- Dante Connection: 2 x RJ-45, Internally routable with Ultimo 4x4 module
- Ethernet Connection: RJ-45
- USB Connection: Micro USB on front panel for firmware updates
- IRDA: IR transceiver for sync of receivers
- Input impedance: Line: 2kΩ
- Headphone jack: ¼" stereo (TRS)
- Power Requirements: 9-18VDC
- Power Consumption: 5 Watts
- Dimensions (H x W x D): 1.750" x 8.375" x 7.750" (44.45 x 212.7 x 196.8mm)
