NotaBotYet Tally Helper 500

NotaBotYet Tally Helper 500

• Phoenix-type screw terminal strip for connecting tally wires from up to 5 Mika mic booms
• Included 12V regulated switching power supply.
• Two RJ-45 input connectors (One for Red and One for White) with pinouts matching our Axia GPIO Breakout Board (Part# A15-B01-2) or Wheatnet IP logic ports.
• Active low inputs mean installers can use any standard GPIO source (using open collector type closures to ground or relay closures to ground) to control the device
• Small device (no larger than a surface mount phone jack) can be mounted discreetly in any location convenient for access and wiring.

Sometimes, when building a facility, there just needs to be an easy way to control the tally light on multiple Yellowtec Mika microphone booms. For a facility designer and/or installer, this usually means termination of the Mika mic boom cable on a 5 pin xlr or equivalent method and somehow splitting off the power lines for the tally light from the mic audio lines. But then what happens? Punch blocks? Perf Boards? Spaghetti and relays?

This all takes a lot of time, effort, soldering and it never ends up as clean or neat as one would hope. Wouldn’t it be nice if something came along to help make the installation cleaner? And by the way, now that Mika tally lights can glow Red or White depending on the polarity of the voltage feeding it…so wouldn’t it be nice if a simple GPIO bit could trigger either the red or white tally lights, finally allowing use of both colors?

Enter the Tally Helper 500. Like its little brother, the Tally Helper 100, when installing Mika mic booms, it can make some of life’s problems disappear. Imagine having a nice clean phoenix-type screw terminal strip sitting there just waiting to have each of the tally wires locked down for a good, tight electrical connection. Imagine not having to loop through a relay, krone block, scotch tape, or anything. Imagine having a power supply that connects to the device and provide a solid 12 volts of regulated power for up to five Mika mic booms. Imagine an two easy RJ-45 connectors waiting to be plugged into a Axia GPIO ports or Wheatnet Logic ports or any standard GPIO type output that provide a closures to ground to activate. Imagine being able to decide which GPIO input bit will trigger the red tally and which will trigger the white tally. While that is quite an imagination, it is all real and ready to help.