Overview
Shure SLXD124+/85M-G57, Wireless Combo System, with SM58® Handheld and WL185m Lavalier Microphones, G57 470-608MHz
Featuring the legendary SM58® Cardioid Dynamic Microphone capsule on the SLXD2+ handheld transmitter and the SLXD1+ wireless bodypack transmitter with WL185m lavalier. The SLXD124+/85M unlocks a new world of hands-free oversight and management for seasoned volunteers and pro engineers alike that delivers wireless excellence, wherever required.
Features
- Transparent 24-bit digital audio quality with >118 dB dynamic range
- Rock solid RF with 138 MHz wide-tuning range for greater geographical coverage:
- Up to 11 simultaneous systems in 6 MHz TV bands
- Up to 14 simultaneous systems in 8 MHz TV bands
- Automatic Setup – once linked, SLX-D+ receivers and transmitters stay connected, despite any RF interference
- With ShowLink® Ease, transmitter parameters can be adjusted remotely over the air from the linked receiver, including:
- Changing the transmitter frequency once open frequency is identified
- Adjust power output level
- Lock and unlock transmitter controls
- Transmitter firmware updates
- Monitor RF status and control receiver and transmitter parameters with Wireless Workbench desktop software, or remotely with the WWB Mobile app over Wi-Fi or Bluetooth
- Patented Shure Digital Feedback Reducer software is embedded in every SLX-D+ receiver, to automatically reduce unwanted audio feedback, should it ever occur.
- Each SLX-D+ component and system ships with AES-256 Encryption installed, for complete and secure peace of mind
- Up to 8 hours of use from either 2 AA batteries (included) or optional Shure SB903 Li-ion rechargeable batteries and charging accessories
In The Box:
- 1 SLXD4+ Digital Wireless Receiver
- 1 SLXD1+ Bodypack Transmitter
- 1 SLXD2+/58 Digital Wireless Handheld Transmitter with SM58® Vocal Microphone
- 1 rackmount kit
- 4 AA batteries
- 1 power supply
- 1 WL185m Low-Profile Cardioid Lavalier Microphone
- 1 single-mount tie clip
- 1 snap-fit windscreen
- 2 carrying pouches
Specifications / Documents
SLXD1+ Bodypack Transmitter
- Audio Output
- Connector: 4-pin Male Mini Connector (TA4M)
- Configuration: Unbalanced
- Impedance: 1MΩ
- Maximum Input Level: 8.2dBV (2.57Vrms, 7.27Vpp)
- Preamplifier Equivalent Input Noise (EIN): -118dBV
- RF Output
- Antenna Type: ¼ Wave
- Occupied Bandwidth: <200kHz
- Modulation Type: Shure Proprietary Digital
- Power: 1 mW/10 mW (Varies by region)
- General
- Battery Type: Rechargeable Li-Ion or 1.5V AA Batteries
- Dimensions (HxWxD): 3.86" x 2.68" x 1.0" (98mm x 68mm x 25.5mm)
- Weight: 3.1oz (89g)
- Housing: PC/ABS
SLXD2+/58 Handheld Transmitter
- Audio Input
- Configuration: Unbalanced
- Maximum Input Level: 8.2dBV (2.57Vrms, 7.27Vpp)
- RF Output
- Antenna Type: Integrated Single-Band Helical
- Occupied Bandwidth: <200kHz
- Modulation Type: Shure Proprietary Digital
- Power: 1mW/10mW (Varies by region)
- General
- Battery Type: Rechargeable Li-Ion or 1.5V AA Batteries
- Dimensions (Diameter x L): 1.46" x 6.93 " (37.1mm x 176mm)
- Weight: 5.1oz (144g)
- Housing: Aluminum
SLDX4+ Single-Channel Receiver
- Audio Output
- Audio Frequency Response: 20Hz - 20kHz (+1dB, -2dB)
- Gain Adjustment Range: -18dB - +42dB in 1dB steps
- Configuration:
- ¼": Balanced (Tip=audio +, Ring=audio -, Sleeve=ground)
- XLR: Balanced (1=ground, 2=audio +, 3=audio -)
- Impedance:
- ¼": 1.1kΩ (550Ω Unbalanced)
- XLR (line): 500Ω (250Ω Unbalanced)
- XLR (mic): 150Ω
- Full Scale Output:
- ¼": +12dBV Unbalanced (+18dBV Balanced)
- XLR (LINE setting): +18dBV
- XLR (MIC setting): -12dBV
- Mic/Line Switch: 30dB pad
- Phantom Power Protection
- ¼": Yes
- XLR: Yes
- RF Output
- Spurious Rejection: >75dB Typical
- Connector Type: BNC
- Impedance: 50Ω
- Bias Voltage: 15V DC, 150mA Maximum per antenna (Switchable on-off)
- Networking
- Network Interface: 20Hz - 20kHz (+1dB, -2dB)
- Network Addressing Capability: DHCP or Manual IP Address
- Maximum Cable Length: 328ft (100m)
- General
- Dimensions (HxWxD): 1.65" x 15.47" x 5.98" (42mm x 393mm x 152mm)
- Weight: 61.7oz (1750g)
- Housing: Galvanized Steel
- Power Requirements: 15V @ 0.9
- TAA Compliant: Yes
